|
DRILLING UNIT: |
| |
Wilson Mogul 42B D/D Back-In Unit, Lebus Grooved f/1” Drill Line,
9/16” Sand Line, Catwheel, Air & Hydraulically Operated Controls,
15” Water Brakes |
| |
MAST / SUBSTRUCTURE: |
| |
Wilson 96’ – 180,000# SHL Telescoping Mast, Hydraulically Raised & Scoped, 3 – Stage Raising Ram, Crown Block w/ (4) 28” Sheaves,
3-I/2” Standpipe, Crown Safety Platform, Racking Board, 1” Fast-line
Sheave, 1” Line, Counter Weights, ladder, Standpipe Manifold w/
1” & 3-1/2” Gate Valves, OTECO Pressure Gauges, 8’ H x 8’ W x 12’L Sub w/ V-Door Ramp, (2) Stairs, Safety Rails. ALL ABOVE Mounted on WILSON 5-Axle CARRIER p/b DETROIR 8V-92 Diesel Engine w/ Electric Starter, Radiator Gauges, Allison 750CLBT Trans, Hyd Pump, BENDIX Air Compressor, Hyd Utility Winch, Air Receiver Tanks, Hyd Reservoir, Water Tank, (2) Fuel Tanks (4) Leveling Jacks, Dead Line Anchor, Folding Walkways, Stairs, Safety Rails. |
| |
PUMP: |
| |
Wilson 600 Duplex Mud Pump, 600 HP, 7-1/4” x 14”, Forged Steel
Fluid End w/ Quick Change Valve & Cal Head Caps, HYDRILL
K-20-3000 Pulsation Dampner, OTECO 2” Sheave Relief Valve, Rod
Cooling Pump, Rebuilt Type E 6000 psi Pressure Gauge, OTECO
4” Gate Valve Suction Hoist, Drive Assembly, Master Skidded w/ Eng. |
| |
PUMP POWER: |
| |
CAT 353 Diesel Engine w/ Air Starter, Radiator, Gauges, Air Clutch. |
| |
PUMP: |
| |
GARDER-DENVER FO-FXO Duplex Mud Pump, 5” x !0”, Cast Steel
Fluid End w/ Bolted Valve & Cyl Head Caps, Air surge Chamber,
OTECO 2” Sheave Relief Valve, Rod Cooling Pump, HARRISBURG
6000 psi Pressure Gauge, OTECO 4” Gate Valve, Suction Hoist,
Drive Assembly, Master Skidded w/ Engine. |
| |
PUMP POWER: |
| |
Detroit 6V-71 Diesel Engine w/ Electric Starter, Radiator, Gauges
TWIN DISC Air Clutch. |
| |
ROTATING EQUIPMENT: |
| |
HACKER A-15-T 15” Rotary Table w/ Split Master Bushing
KING 10MB Swivel, 3-1/2” x 38’ L Square Kelly, Kelly Drive, Square Dr |
| |
TRAVELING EQUIPMENT: |
| |
WILSON 100-Ton Block / Hook Combination w/ (4) Sheaves, 1” Line
2” x 72” Elevator Links. |
| |
RIG HOUSES: |
| |
TERRY 8’W x 21’L, 2 Axle Toolpusher’s Trailer, Fully Furnished w/
Refrigerator, Microwave, Bed & Bath. 8’W x 40’L T/A Van Trailer
Doghouse w/ Flat Top, Lockers, Bench Storage, Parts Bin, Space
Heater, Refrigerator, Microwave, Fluorescent Lights. |
| |
MUD SYSTEM: |
| |
thOMPSON T3 Rotating Shale Shaker. |
| |
WATER / FUEL TANK: |
| |
8’W x 5’H x 36’L Water Tank w/ (2) Compartments, V-Bottom, Skidded. |
| |
HANDLING TOOLS: |
| |
Wilson Type C Rotary Tools w/ Extra Heads
3-1/2” BN Center Latch Drill Pipe Elevators
3-1/2” SS Center Latch Drill Collar Elevators
3-1/2” Drill Pipe Slips
6” Drill Collar Slips
6 – Segment Drill Collar Safety Clamp
Drill Collar Lift Subs & Lift Nubbins |
| |
AUXILLARY EQUIPMENT: |
| |
BERKLEY Cent Water Pump p/b Detroit 4-71 Engine
With Electric Starter, Radiator, PTO, Day Tank Skidded
MARTIN DECKER Clipper 280,000# Capacity Wt. Indicator-Console
3-1/2” ID x 45’L Rotary Hose
Approx. 1,000’ of 1” Drill Line w/ Spool
60 KW Gen p/b CAT 3406 Diesel, w/ Elect Starter, Radiator, Skidded
(2) 500-Gal Round Fuel tank w/ 2” Hard Line
ALL Above mounted on 40’L T/A Float, Landing Gear, Junk Bin,
Sliding Tandem, 11R 24.5 Tires. |
| |
DRILL PIPE: |
| |
3-1/2”, Grade E, 13.30#, Rng 2 Drill Pipe w/ 3-1/2” IF, BN Tool Joints. |
| |
|